Assembly Flow Measuring System - GERATHERM Diffustik Instructions For Use Manual

Instructions for Use
Diffustik / Variant PFTstik
Serial no.: xx|8|401|yyy and 2401xxxxx
Before the Diffustik resp. the variant PFTstik can be used to
perform measurements again, all components must be properly
reconnected, the USB connection to the computer must be
established, and the Diffustik resp. the variant PFTstik must be
connected to the power supply and calibrated. Calibration also
fulfils the regulatory requirements for functional testing after
maintenance work.
Please proceed as described in the respective chapters.
6.2.1

Assembly Flow Measuring System

Version: 8 | Release date: 16. August 2021
Possible danger to life
Reason: Electric shock. Therefore:
•
Never obstruct the access to the mains plug or
On / Off switch of the equipment cart!
Disconnection of the power supply must be
easily accessible!
Possible physical injury.
Reason: Measurement error due to leakage caused by
incorrect assembly of components. Therefore:
•
Carefully observe the assembly instructions!
Reason: Height-adjustable arm, device, or complete
cart falls over. Therefore:
•
Never change pre-assembled height-adjustable
arm!
•
Do not attach any other components to the
device!
•
Do not lean on the height-adjustable arm or hold
on to it!
Page 55