Table of Contents
Advertisement
Setup
8. Connect chiller with 1/4" tubing.
F
. 13: Chiller Connections
IG
9. Perform Startup procedure on
page 17.
10.Perform Human Machine Interface
(HMI) setup.
Refer to Appendix A - HMI Screens Overview starting
on page 86 for more information.
a. Navigate to DRIVE/VALVE setup screen. Push
the ENABLE drive button for each component to
enable the drives.
b. If the drives have been unplugged, refer to
Appendix C - Setting Home Position on
Pumps starting page 105.
c. Verify the indicators read that each drive is
HOME. If not, push the HOME PUMP push but-
ton.
16
Coolant
In
Coolant
Out
ti18201a
11.Perform Flushing Procedure start-
ing on page 19.
NOTICE
The machine is tested with oil at the factory. Flush
out the oil with a compatible solvent before loading
the machine with material.
12.Perform System Calibration Pro-
cedure starting on page 23.
3A2152B
Advertisement
Table of Contents
