Graco LSR Select Instructions Manual page 14

Setup
5. Install Feed System.
Feed components are purchased separately and not a
part of this system.
NOTICE
Use at least 10 layers of PTFE tape and use pipe
dope on the fluid inlet fitting to prevent galling.
Recommended feed parameters:
• Base feed pressure:
Load base pump with 300-800 psi fluid pres-
sure.
• Base fluid hose connection:
1" NPT male.
• Inhibitor/Catalyst/Color feed pressure:
Load 1093's with 200-400 psi fluid pressure.
• Inhibitor/Catalyst/Color hose connection:
JIC(04)
1" Inlet
F . 6: 1" NPT Base Inlet Connection
IG
F . 7: Connection Port
IG
14
ti18100a
(Other connec-
tions are found on
other side of
visual)
ti18101a
6. Connect the Base Pump to the
Valve Stack.
a. Connect the fluid hose from the outlet of the
base pump to the inlet of the Valve stack.
NOTICE
Use at least 10 layers of PTFE tape and use pipe
dope on the fluid inlet fitting to prevent galling.
F . 8: Base Outlet to Valve Stack Connection
IG
b. Connect the motor cables in the first conduit to
the matching servo motors on the valve stack.
c. Connect the encoder cables in the second con-
duit to the matching servo motors on the valve
stack.
Motor
Cables
Encoder
Cables
F . 9: Electrical Cable Connections
IG
ti18102a
ti18103a
3A2152B