Graco LSR Select Instructions Manual page 15

d. Connect the sensor lines and solenoid lines in
the third conduit to the matching valves on the
valve stack.
e. If using kit 24M127, connect the pressure trans-
ducer cables in the third conduit to the matching
transducers on the valve stack.
f. Connect the ground wire in the sensor conduit
to the screw holding the solenoid valves to the
stack.
g. A set of clamps is supplied to keep the three
sections of conduit together. This can be
mounted on the press.
F . 10: Clamps
IG
3A2152B
7. Connect the Air Supply.
To prevent machine damage, air supply must be fil-
tered and dried.
a. Connect a 1/4" in. air supply to the solenoid
valve inlet on the valve stack.
F . 11: Air Supply Connection - Valve Stack
IG
ti18104a
b. Connect a 1/4 in. air supply to the solenoid
valve inlet on the base frame.
1/4" Air
Supply
F . 12: Air Supply Connection - Base
IG
NOTICE
1/4" Air
Supply
ti18105a
ti18106a
Setup
15