Graco LSR Select Instructions Manual page 13

Ground the system.
3.
This equipment must be grounded.
a. Control enclosure and pump: grounded through
power cord. See Connect the electrical cord.
on page 12.
b. Valve stack: Follow your local code.
c. Fluid supply containers: Follow your local code.
d. Solvent pails used when flushing: follow your
local code. Use only metal pails, which are con-
ductive, placed on a grounded surface. Do not
place pail on a nonconductive surface, such as
paper or cardboard, which interrupts grounding
continuity.
e. To maintain grounding continuity when flushing
or relieving pressure, hold grounded metal pail
firmly to a metal part of dispense valve then initi-
ate a dispense.
3A2152B
4. Connect the press output signal to
the customer input located in the
panel.
Add customer signal from the press when the press is
ready to load the screw by either:
a. Connecting a 24 VDC signal from the press to
the relay CR-CS.
CUSTOMER START
CONNECT 24VDC START
SIGNAL FROM PRESS
F . 5: Relay CR-CS
IG
b. Connecting a dry contact signal across lines 8
and 6850 on the terminal assembly. Refer to
Control Schematics, 24L890, page 76, for
additional clarity.
A1 A2
123386
CR-CS
Setup
13