Table of Contents
Advertisement
This menu allows you to configure the alarm settings.
This menu allows you to configure the HDD that the NVR uses for saving the recordings. You need to format the HDD only at the first startup and if you replace the HDD.
Alarm: Alarm & Device: HDD
• Alarm In:
Select the IO alarm sensor.
• Alarm Type:
Select the alarm sensor type: NO (Normal-Open), NC (Normal-Close), or OFF.
•
Buzzer: Set the buzzer duration when the alarm sensor is triggered. To disable buzzer, select OFF.
• Latch Time:
Select the alarm sound duration of the I/O alarm device.
• Post
Recording:
sensor is triggered.
• Alarm Out:
If an alarm device is connected, check the box to make the device sound the alarm
when the alarm sensor is triggered.
• Show Message/Sent
you an auto-email when the alarm sensor is triggered.
• Full
Screen: If this function is enabled and the alarm sensor is triggered, the corresponding channel
will be displayed in full screen.
• Record
Channel:
• Format HDD:
Select the HDD you want to format and then click Format HDD. To start formatting,
you need to enter your user name and password and then click OK to confirm to continue
formatting.
•
Overwrite: Use this option to overwrite the old recordings on the HDD when the HDD is full. For
example, if you choose the option 7 days then only the last 7 days recordings are kept on the HDD.
To prevent overwriting any old recordings, select Disable. If you have disabled this function, please
check the HDD status regularly, to make sure the HDD is not full.
Here you can configure how long the NVR will continue to record after the alarm
Email: Check the box to display a message on screen or let the NVR to send
Select which channels start to record when the alarm sensor is triggered.
Mars PRO Series NVR
27
Advertisement
Table of Contents
