Rosslare Multi-Smart AY-K35 Installation & User Manual page 4

To connect the reader to the controller:
1. Select the appropriate connections according to the table below.
2. Prepare the controller cable by cutting its jacket back about 3 cm (1¼ in.) and strip the insulation from the wires
about 1.3 cm (½ in.).
3. Splice the reader's pigtail wires to the corresponding controller wires and cover each joint with insulating tape.
4. If the tamper output is being utilized, connect the purple wire to the correct input on the controller.
5. Trim and insulate the ends of all unused conductors individually. Do not short any unused wires together.
Wire Color
Red
Black
Green
White
Orange
Brown
Purple
Yellow
Blue
Gray
Pink
Black (shrink)
4. Configuration
1. Download the Rosslare BLE-Admin application from Google Play or Apple App Store using the following QR code.
2. Open the application, select the required reader from the list displayed.
www.rosslaresecurity.com
Function
Power
Ground
Data 0 / Data
Data 1 / Clock
Green LED Control
Red LED Control
Tamper Output
Buzzer Control
RS-485 - A / OSDP
RS-485 - B / OSDP
Touch Button
Shield
4
Multi-Smart™ Readers Installation & User Guide