Set Up Charging; Information/Status Led; Charger Status - Polaris PIXEL ET37 Series Owner's Manual

Polaris PIXEL Cordless Robotic Cleaner | Owner's Manual
® ™
3.1

Set Up Charging

1. Select an indoor charging location (GFCI
outlet) at least 11.5 ft (3.5 m) away from the
pool, out of direct sunlight, rain or inclement
weather.
GFCI
TEST
RESET
Figure 2. Charging Location
2. Plug charger into a GFCI outlet.
3. Before using the cleaner for the first time, fully
charge the cleaner until the battery indicator
shows solid green.
.
3.2

Information/Status LED

While Charging
Ready to Start
(unplugged)
During Cycle
IMPORTANT: The Cleaner goes into deep sleep after 8 days of inactivity to protect the battery. When all
indicators are off, the cleaner is in sleep mode. Plug in the charger to wake it up. If this does not work, see
"Troubleshooting" on page 13.
3.3

Charger Status

11.5 ft
(3.5 m)
Solid Green
Blinking Green
Blinking Orange
Blinking Red
Solid Green
Solid Orange
Blinking Orange
Blinking Red
Solid Green
Solid Orange
Blinking Red
Off
Solid Green
Solid Red
Solid Green
4. Dry the cleaner and charging contacts, then
charge the cleaner before every cleaning cycle.
The battery indicator slowly blinks orange
while charging, slowly blinks green when it can
be used to run a cycle, and shows solid green
when fully charged.
Failure to comply with the following warnings can result in permanent
injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK AND FIRE
• Only connect the charger to a receptacle protected by a ground fault
circuit interrupter (GFCI). Contact a certified electrician if you cannot
verify that the receptacle is protected by a GFCI.
• Do not use an extension cord to connect the charger.
• Do not allow anyone to swim while the cleaner is in the pool.
• Follow all charging instructions and do not charge cleaner outside
of the temperature range specified in the instructions. Charging
improperly or at temperatures outside of the specified range may
damage the battery and increase the risk of fire.
Fully charged
Ready to run a full cycle (1 h 30 min)
Low Battery, charging
Error. See "Troubleshooting" on page 13.
Ready to immerse
Low Battery
Very low battery, cannot run
Error. See "Troubleshooting" on page 13.
Cycle in progress
Low Battery
Error. See "Troubleshooting" on page 13.
Cycle complete
Charger receiving power. Cleaner not plugged into charger.
Cleaner plugged into charger and is charging.
Cleaner plugged into charger and is fully charged.
WARNING
ENGLISH
Page 7