Fan Setting - Gree XK86 Owner's Manual

Wired Controller (XK86 and XE76-33/H)
NOTES:
① After Absence function is enabled, pressing "▲" or "▼" button can not
change the temperature.
② Under Auto mode, wired controller cannot enter the interface of temperature
setting. You can set the cooling temperature and heating temperature of
Auto mode in project parameter setting.
③ Under Auto Dry mode or Absence mode, homepage will not display set
temperature and wired controller cannot enter the interface of temperature
setting. Temperature can only be adjusted in project parameter setting.
④ Under Dry Reheat mode, you can enter the interface of temperature setting
and set the temperature and relative humidity at the same time.
⑤ If wired controller is connected to fresh air indoor unit, homepage will not
display set temperature. Temperature display zone will display the code of
fresh air indoor unit "FAP". Wired controller cannot enter the interface of
temperature setting. Cooling temperature and heating temperature can only
be set in project parameter setting.
⑥ If wired controller is connected to temperature-humidity dual-control duct
type indoor unit, pressing "▲" or "▼" button can increase or decrease
temperature by 0.5℃.

6.4 Fan Setting

Under ON status, pressing "Fan" button on homepage can switch fan speed
circularly in the following order:
Auto->Low->Medium Low->Medium->Medium High->High->Auto
34