Wired Controller (XK86 and XE76-33/H)
NOTES:
① Under the status of parameter enquiry, signals from remote controller are
ineffective.
② If a parameter is invalid, wired controller displays "—".
5.2.2 Parameter Setting
Unit parameters can be set in unit On or Off status.
Press "Menu" button on homepage to enter the menu page. Then select "Set" to
enter the interface of settings. Then select "Project set" to enter the interface of
project parameter setting, as shown below. Please refer to table 5.2 for the list of
parameter settings.
Press "▲" or "▼" to switch among different settings. Press and hold the buttons
to switch quickly.
26