Table of Contents
Advertisement
Available languages
Available languages
•
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
Guarantee
1 Year Guarantee
All STANLEY FATMAX power tool products include a 1 year
guarantee as standard. In the unlikely event that your powertool
becomes defective due to faulty materials or worksmanship
within 1 year of purchase, STANLEY guarantees to replace or
repair all defective parts free of charge, or – at our discretion –
replace the item free of charge.
3 Year Guarantee
Register your STANLEY FATMAX power tool within 4 weeks
of purchase and qualify for an additional 2 year guarantee.
Having registered your power tool, in the unlikely event that
your powertool becomes defective due to faulty materials or
worksmanship, STANLEY guarantees to replace or repair all
defective parts free of charge, or – at our discretion – replace the
item free of charge.
TROUBLESHOOTING
Problem
Solution
Unit will not start.
•
Check battery installation.
•
Check battery
charging requirements.
•
Check that lock off is fully pushed
down prior to moving main trigger.
Unit shuts down
•
Charge battery.
in use.
•
Unit is being forced. Restart and
apply less pressure.
Battery
•
Insert battery into charger until red
won't charge.
charging light illuminates. Charge up
to 8 hours if battery is totally drained.
•
Plug charger into a working outlet.
Refer to Important Charging Notes
for more details.
•
Check current at receptacle by
plugging an appliance.
•
Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
•
Move charger and appliance to
a surrounding air temperature of
above 4.5 °C or below 40.5 °C.
Bar /
•
Refer to Adjusting Chain
Chain overheated.
Tension section.
•
Refer to Chain Oiling section.
Chain is loose.
•
Refer to Adjusting Chain
Tension section.
Problem
Solution
Poor cut quality.
•
Refer to Adjusting Chain
Tension section. nOTE: Excessive
tension leads to excessive wear and
reduction in life of bar and chain.
Lubricate before each cut. Refer to
Replacing the Saw Chain section.
Unit runs but does
•
Chain could be installed backwards.
not cut.
Refer to sections for installing and
removing chain.
Unit does not oil.
•
Refill oil reservoir.
•
Clean guide bar, sprocket and
sprocket cover. Refer to Care And
Maintenance section.
English
17
Advertisement
Table of Contents
