Error Messages; Safety, Care, Accuracy Test And Disposal; Safety And Protection - Microlife BP A150 AFIB Manual

2. Plug the adapter plug into the wall socket.
When the mains adapter is connected, no battery current is
consumed.

10. Error Messages

If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g. «ERR 3», is displayed.
Error Description Potential cause and remedy
«ERR 1» Signal too The pulse signals on the cuff are too
weak weak. Re-position the cuff and repeat the
measurement.*
«ERR 2» Error signal During the measurement, error signals
were detected by the cuff, caused for
AR
instance by movement or muscle
tension. Repeat the measurement,
keeping your arm still.
«ERR 3» No pressure An adequate pressure cannot be gener-
in the cuff ated in the cuff. A leak may have
AS
occurred. Check that the cuff is correctly
connected and is not too loose. Replace
the batteries if necessary. Repeat the
measurement.
«ERR 5» Abnormal The measuring signals are inaccurate
result and no result can therefore be displayed.
Read through the checklist for
performing reliable measurements and
then repeat the measurement.*
«ERR 6» AFIB/MAM There were too many errors during the
Mode measurement in AFIB/MAM mode,
making it impossible to obtain a final
result. Read through the checklist for
performing reliable measurements and
then repeat the measurement.*
«HI» Pulse or cuff The pressure in the cuff is too high (over
pressure 299 mmHg) OR the pulse is too high
too high (over 200 beats per minute). Relax for
5 minutes and repeat the measurement.*
«LO» Pulse too The pulse is too low (less than 40 beats
low per minute). Repeat the measurement.*
6
* Please immediately consult your doctor, if this or any other
problem occurs repeatedly.

If you think the results are unusual, please read through the
information in «Section 1.» carefully.

11. Safety, Care, Accuracy Test and Disposal

Safety and protection

• Follow instructions for use. This document provides important
product operation and safety information regarding this device.
Please read this document thoroughly before using the device
and keep for future reference.
• This device may only be used for the purposes described in
these instructions. The manufacturer cannot be held liable for
damage caused by incorrect application.
• This device comprises sensitive components and must be
treated with caution. Observe the storage and operating condi-
tions described in the «Technical Specifications» section.
• Protect it from:
- water and moisture
- extreme temperatures
- impact and dropping
- contamination and dust
- direct sunlight
- heat and cold
• The cuffs are sensitive and must be handled with care.
• Do not exchange or use any other kind of cuff or cuff connector
for measuring with this device.
• Only pump up the cuff once fitted.
• Do not use this device close to strong electromagnetic fields
such as mobile telephones or radio installations. Keep a
minimum distance of 3.3 m from such devices when using this
device.
• Do not use this device if you think it is damaged or notice
anything unusual.
• Never open this device.
• If the device is not going to be used for a prolonged period the
batteries should be removed.
• Read the additional safety information provided within the indi-
vidual sections of this instruction manual.
• The measurement results given by this device is not a diag-
nosis. It is not replacing the need for the consultation of a physi-
cian, especially if not matching the patient's symptoms. Do not