Schulte SDX-102 Operator's Manual page 87

4. Slide the Reducer Gearbox off of the shaft.
5. Remove the four bolts that hold the coupler to
the gearbox and remove the coupler.
Installing the Reducer Gearbox
1. Ensure the mounting face of the Snowblower
Mounted Gearbox as well as all mounting faces
of the Gearbox Coupler are clean and free of
dirt and grease. Install the Bearing Cup Race as
well as the seal into the coupler.
2. Apply High Heat Silicone to the face of the
coupler.
3. Press the Coupler into place on the Snowblower Gearbox. (The round side should go towards the chain
case).
SDX-102 05/19
© 2019 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-5