Table of Contents
Advertisement
10. Measure the distance between the end of the snow blower gearbox shaft and the tractor PTO shaft. At any
point in the lifting cycle the two shaft ends must be withing the limits of the table below.
540 RPM
These dimensions will provide the required joint engagement and also ensure that the universal joint halves do
not jam together. It is possible that the power shaft will be too long for some tractor installations. If the power
shaft is too long, extend the 3-point link arms of your snow blower or consult your dealer for further assistance.
SDX-102 05/19
© 2019 Alamo Group Inc.
ASSEMBLY
Table 1:
540 RPM
Minimum
33" (840mm)
Maximum
44" (1,115mm)
Assembly Section 3-4
1000 RPM
30" (760mm)
37" (940mm)
1000 RPM
Advertisement
Table of Contents
