Mindray BeneFusion VP3 Vet Operator's Manual page 77

If the device is operated within the electromagnetic environment listed in Table
Guidance and Declaration —Electromagnetic Immunity, the system will remain
safe and provide the following essential performance:

Operating mode

Accuracy

Function

Protection against UNINTENDED BOLUS volumes

Occlusion

ALARM CONDITIONS regarded

Data stored
Guidance and Declaration - Electromagnetic Immunity
The device is intended for use in the electromagnetic environment specified below. The
customer or the user of the device should assure that it is used in such an environment.
Immunity test IEC 60601 test
level
Electrostatic ± 8 kV contact
discharge ± 15kV air
(ESD)
IEC 61000-4-2
Electrical fast ± 2 kV for power
transient/burst supply lines
IEC 61000-4-4 ± 1 kV for
input/output lines
(length greater
than 3 m)
Surge ± 1 kV line(s) to
IEC 61000-4-5 line(s)
± 2 kV line(s) to
earth
Voltage dips 0 % U
and Voltage cycle
interruptions
IEC 61000-4-11 0 % U
and 70 % U
25/30 cycles
0 % U
cycle
Compliance level
± 8 kV contact
± 15kV air
± 2 kV for power
supply lines
± 1 kV for
input/output lines
(length greater
than 3 m)
± 1 kV line(s) to
line(s)
± 2 kV line(s) to
earth
for 0,5 0 % U
T
cycle
for 1 cycle 0 % U
T
for and 70 % U
T
25/30 cycles
for 250/300 0 % U
T
cycle
B-3
Electromagnetic
environment -
guidance
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should
be at least 30%.
Mains power quality
should be that of a
typical commercial or
hospital environment.
for 0,5 Mains power quality
T
should be that of a
typical commercial or
for 1 cycle hospital environment. If
T
for the user of our product
T
requires continued
operation during power
for 250/300 mains interruptions, it is
T
recommended that our
product be powered
from an uninterruptible