Kit Components; Dash Panel Installation Instructions; Wiring Instructions - Intellitronix DP3001 Installation Manual

KIT COMPONENTS

Two (2) Digital Circuit Board
Two (2) Smoked Acrylic Lenses
* Peel off protective covering from both sides of each lens
One (1) - Temperature Sending Unit (S8013) 1/8" NPT, 0-255 Deg., 1/2" NPT Bushing
One (1) Universal Speedometer Sensor (S9013) 7/8" NPT Industry Standard threads
Hardware Kit
Nine (9) - #4-40 x 1" Black Allen head bolts Nine (9) - #4-40 Nylock Nuts
Nine (9) – #4 x 3/8 spacer Nine (9) - #4 Nylon flat washers
Five (5) – 10x32 Nylock nut Five (5) – 10 32 x 5/8 Phelps head bolt
Note: LS Engines or any other Computer based engine systems most use provides sensors and
install new wires to new sensors

DASH PANEL INSTALLATION INSTRUCTIONS

1. Remove all the gauges from the stock bezel and housing. Place the new
circuit board into the stock gauge housing. Secure into place with stock hardware.
3. Follow the wiring instructions in the next section and wire the circuit boards. At this point you can
utilize the wires from your existing harness or run separate wires to the senders.

WIRING INSTRUCTIONS

Note: Automotive circuit connectors are the preferred method of connecting wires. However, you
may solder if you prefer.
Note: If doing an LS engine swap, pick up the tach signal wire from the ECM/ECU and then program
the tachometer to 4-cylinders. You may also need to order the Intellitronix LS Engine Swap Adapter
Kit – for Series 1, 2 and 3 engines. The part number is 8014LS. If you are getting the tach signal from
the ECU, the resistor in the adapter kit will help pull a stronger signal for the tachometer.
Ground – Black--This is the main ground for the display system. A wire should be run from
this board to the vehicle engine block for the best ground. Use 18 AWG or larger wire to ensure
sufficient grounding. Proper vehicle grounding is extremely important for any gauges (or
electronics) to operate correctly. The engine block should have heavy ground cables to the
battery, frame, and firewall. Failure to properly ground the engine block, senders, or digital dash
can cause incorrect or erratic operation.
Power - Red--Connect the power terminal to accessory +12V power from the fuse panel or
vehicle wiring harness. This terminal should have power when the key is on or in accessory
position. Use 18 AWG wire to ensure the system receives a sufficient power feed.
Dimmer – Purple Connect to the parking lights to dim the LEDs 50% when the headlights are on. However,
*DO NOT * connect to the headlight rheostat control wire, or the dimming feature will not work properly
and may cause damage to Unit.
2 – DP3001 www.intellitronix.com
(rev.02/20/2020)