MacDon M155 Installation Instructions Manual page 3

Self-propelled windrower, oil cooler bypass kit

Hide thumbs Also See for M155:

Table of Contents

Introduction

The Oil Cooler Bypass kit (MD #183518) is used to replace the cooler bypass manifold and the hardware on the

wheel motor servo on an M155 Self-Propelled Windrower. This document explains how to install the kit.

Refer to the parts list to ensure you have all required items before installing this kit.

Installation Time

Installation time for this kit is approximately six hours.

Conventions

The following conventions are followed in this document:

• Right-hand (RH) and left-hand (LH) are determined from the operator's position, facing forward with the windrower

in cab-forward position.

• Unless otherwise noted, use the standard torque values provided in the windrower operator's manual and

technical manual.

NOTE:

Keep your MacDon publications up-to-date. The most current version of this instruction can be downloaded from

our Dealer-only site (https://portal.macdon.com) (login required).

NOTE:

This document is not currently available in any language except English.

147595

Revision B

Table of Contents

Md 183518