MacDon M155 Installation Instructions Manual page 22

Self-propelled windrower, oil cooler bypass kit

Hide thumbs Also See for M155:

Table of Contents

3. To disengage drive wheel and allow wheel to rotate,

remove the two hex bolts (A) at the center of the drive

wheel. Remove cap (B), and ﬂip over so that the dished

side faces in. Replace bolts (A). The cap will press on

a pin that disengages the gearbox.

NOTE:

Disengaging the drive wheel will make it possible

for you to remove the bolts in the next step.

4. Remove the lower six bolts (A) that hold the wheel drive

to the windrower leg. Do NOT remove the two nuts (B)

located at the top of the wheel drive.

5. Remove hex bolts (A) at the center of the drive wheel.

Remove cap (B), and ﬂip over so that the dished

side faces in.

Replace bolts.

re-engaged.

147595

INSTALLATION INSTRUCTIONS

The drive wheel is

Figure 3.15: Drive Wheel Motor with Center Cap

Disengaged

Figure 3.16: Wheel Drive

Figure 3.17: Drive Wheel Motor with Center Cap

Disengaged

Revision B

Table of Contents

Md 183518