DAVIS Wireless Temperature/Humidity Station Instruction Manual page 9

Fan-aspirated wireless temperature/humidity station

Hide thumbs Also See for Wireless Temperature/Humidity Station:

Table of Contents

Check the Junction Board cable connections: SIM Sensor, SIM Power (SIM),

Motor, Temp/Hum Sensor, and Solar Panel (SOL).

Install the Junction Board Cover as show below. The Junction Board Cover

presses easily into place when you are installing it. To remove the cover,

press gently in on both sides to release the latches holding it in place.

Junction Board Cover

Junction Board

Slide the two sections of the Radiation Shield completely together.

Place the ﬂat washers, lock washers and plastic wing nuts over the

threaded rods.

Finger-tighten the wing nuts until they hold the radiation shield plates

ﬁrmly in place.

Setting the DavisTalk Transmitter ID

Sensor

SIM

Interface

Power

Cable

Solar

Panel

Cable

Junction Board Cable Connections

Junction Board Cover Installation

Press in on Sides

near latches

to Remove Cover

Page 9

Table of Contents

Need help?

Do you have a question about the Wireless Temperature/Humidity Station and is the answer not in the manual?

Temperature/humidity