DAVIS Wireless Temperature/Humidity Station Instruction Manual page 6

ID C
#1
Use this table to ensure that each wireless transmitting station in your system is
broadcasting on a unique transmitter ID.
DIP Switches in Top-right Corner of SIM (Illustration has been enlarged for clarity)
Setting Console/Receiver(s) to Same ID
Note: See the Vantage Pro User's Manual & Setup Guide : "Setup Mode – Screen 2: Selecting
Transmitters" for more detailed instructions.
1. Put your console into Setup Mode — press and hold the DONE key and
press the DOWN arrow key.
The console will display Screen 1: Transmitters. You should see the words:
"RECEIVING FROM..." and "STATION NO." followed by the transmitter
IDs that your console detects. One of these should be the ID number you
just set on the station's transmitter. If you don't see it, move the console to
within 10' of the transmitter and verify that the station's transmitter ID
switches have been set correctly. If you still don't see station's ID, refer to
the "TEST Mode" section on the next page.
2. Press the DONE key to move on to Screen 2: Selecting Transmitters.
Setup Mode – Screen 2 is where you will set the console to recognize the
signals from your Aspirated Temp/Hum Station.
3. Press the LEFT or RIGHT arrow key, or the STATION key, to scroll through
transmitter IDs.
When you see the transmitter ID you chose for your station, use the UP or
DOWN arrow keys to set the reception of that ID code to "ON".
Page 6
S 1
ODE WITCH
off
(default)
#2 off
#3 off
#4 off
#5 ON
#6 ON
#7 ON
#8 ON
Battery Holder
S 2 S
WITCH WITCH
off off
off ON
ON off
ON ON
off off
off ON
ON off
ON ON
Antenna
ON
1 2 3 4
Wireless Temperature/Humidity Station
3
Transmitter ID
Switches
Test Indicator LED