Setting The Davistalk Transmitter Id - DAVIS Wireless Temperature/Humidity Station Instruction Manual

2. Insert the 3-volt lithium battery into the battery holder, matching the "+"
sign on the battery with the "+" sign on the SIM.
Consult this drawing to locate the transmitter ID switches. You will work
with them during the next installation step.
SIM Power Cable

Setting the DavisTalk Transmitter ID

Each wireless transmitting station must be set to one of eight DavisTalk trans-
mitter IDs. Use the transmitter ID switches #1, 2 and 3 to set the station's ID.
Switch #4 is only used for transmission testing.
Note: The transmitter and receiver communicate with each other only when both are set to the same ID.
The factory default transmitter ID is "1". Looking at the table on the next page,
you can see that means the transmitter ID switches are in the OFF position when
each transmitting station leaves the factory.
Be sure to select a unique DavisTalk transmitter ID for your Aspirate
Temp/Hum station.
Use a ballpoint pen or paper clip to toggle DIP switches #1, 2, and 3. The set-
tings for transmitter IDs 1 – 8 are shown in the following table:
Setting the DavisTalk Transmitter ID
Transmitter
ID Switches
3-Volt
Lithium Battery
Sensor Interface
Cable
Sensor Interface Module on Temperature/Humidity Station
Solar Panel Cable
Page 5