Tools Needed; Installation Steps - DAVIS Wireless Temperature/Humidity Station Instruction Manual

1-1/2" U-Bolts (2)
1/4" Flat Washers (4)
1/4" Hex-Nuts (4)

Tools Needed

You may need the following tools to install your Aspirated Temp/Hum Station:
A medium Phillips-Head screwdriver.
A small wrench or 3/8" (9 mm) nutdriver.

Installation Steps

The Aspirated Temp/Hum Station comes pre-assembled. You will need to dis-
assemble your station to prepare it for operation.
Here are the installation steps for your station:
1. Disassemble the station.
2. Install the Sensor Interface Module (SIM) batteries.
3. Configure the DavisTalk transmitter ID code.
4. Install the fan batteries.
5. Reassemble the station.
6. Choose a location for the station.
7. Mount the station.
Page 2
#4 Self-Threading
Screws (4)
Battery Covers (2)
1.2 Volt Nicad
Batteries (2)
O-Rings (2)
Supplied by customer
for wall or post mounting:
Components, Part 2
1/4" x 1-1/2"
Lag Screws (4)
Wireless Temperature/Humidity Station