DAVIS Wireless Temperature/Humidity Station Instruction Manual page 12

Mounting on a Pole or Mast
Use a pole having an outside diameter between 1 " and 1-1/4 " (25 – 31 mm).
1. Slide the stud ends protrud-
ing from the top of the sta-
tion through the holes on
the mounting bracket.
2. Secure the station to the
mounting bracket using a
#8 flat washer, #8 split lock
washer and #8 hex nut one
each of the stud ends.
Tighten the hex nuts until
the station is secure on the
mounting bracket.
3. Hold the mounting bracket
against the pole. Put two
U-bolts around the pole
and insert the ends through
the holes in the back of the
mounting bracket.
4. Secure the mount-
ing bracket using
1/4" flat washers
and 1/4" hex nuts.
Tighten four set of
the washers and hex
nuts until the
mounting bracket is
firmly mounted on
the pole.
Page 12
Mounting
Bracket
Attaching Temperature/Humidity Station to
1-1/2" U-Bolts
#8 Hex Nuts
#8 Lock Washers
#8 Flat Washers
Mounting Bracket
1/4" Hex Nuts
1/4" Flat Washers
Mounting on a Pole
Wireless Temperature/Humidity Station