DAVIS Wireless Temperature/Humidity Station Instruction Manual page 13

Mounting on a Post or Wall
1. Using four 1/4" x 1-1/2" lag screws (not included), attach the mounting
bracket to the surface in the desired location. A mounting template is
located on page 15.
Drill holes using a 3/16" (5 mm) drill bit. Use a carpenter's level when
marking the holes, to ensure that the bracket will be level.
1/4" x 1-1/2"
Lag Screws
Mounting
Bracket
2. Slide the stud ends protruding from the top of the station through the holes
on the mounting bracket.
3. Secure the station to the mounting bracket using a #8 flat washer, #8 split
lock washer and #8 hex nut on each of the stud ends.
Tighten the hex nuts until the station is secure on the mounting bracket.
Mounting the Station
Attaching Mounting Bracket to a Post
#8 Hex Nuts
#8 Lock Washers
#8 Flat Washers
Mounting to a Post
OR
Page 13