Table of Contents
Advertisement
T
M
OOLS AND
In addition to the components listed above, you may need some of the follow-
ing tools and materials.
Flat-Bladed Screwdriver
Phillips Screwdriver
Adjustable Wrench
Wire Cutter or Scissors
Electrical Tape
Cable Clips or Weather Resistant Cable Ties
With screw holes and screws or other means for mounting
Hammer
I
NSTALLATION
This manual takes you through the step-by-step process of installing your
weather station. These steps are indicated below, along with their page num-
bers for easy reference:
Assemble and test the station, page 3
Detach the extension tube, page 3
Attach the anemometer, page 3
Attach the wind cups, page 3
Snip the cable tie in the rain collector, page 4
Apply power to the console, page 4
Plug cable from sensor array into console, page 5
Check that the console and sensors are working properly, page 5
Re-attach rain collector cone and unplug sensor array cable from
console, page 5
Install the station, page 5
Choose locations for the sensor array and console, page 5
Mount and secure the sensor array, page 5
Run sensor array cable to console, page 7
Mount the console, page 7
If, once installed, you encounter any problems with the station, please refer to
the troubleshooting guide on page 8 or call our technical support line for assis-
tance.
Page 2
N
ATERIALS
EEDED
S
TEPS
EZ-Mount Weather Station
Advertisement
Table of Contents
