Mount The Temperature/Humidity Station - DAVIS Wireless Temperature/Humidity Station Install Manual

3. Hold the mounting bracket against the pole. Put two U-bolts around the pole and
insert the ends through the holes in the back of the mounting bracket.
4. Secure the mounting bracket using 1/4" flat washers and 1/4" hex nuts.
Tighten four set of the washers and hex nuts until the mounting bracket is
firmly mounted on the pole.
1/4" Flat Washer
1/4" Hex Nut
Temperature/
Humidity Station
Mounting on a Vertical Surface
1. Using four 1/4" x 1-1/2" lag screws (not included), attach the mounting bracket to the
surface in the desired location.
Drill holes using a 3/16" (5 mm) drill bit. Use a carpenter's level when mark-
ing the holes, to ensure that the bracket will be level.
Mounting the Temperature/Humidity Station
M
OUNTING ON A
A M B
TTACHING OUNTING RACKET TO A
1-1/2" U-Bolts
P
OLE
P
OST
Page 9