Lithium Battery - DAVIS Wireless Temperature/Humidity Station Install Manual

Applying Power
Insert the 3-volt lithium battery into the battery holder, matching the "+" sign
on the battery with the "+" sign on the SIM.
Consult this drawing to locate the DIP switches. You will work with them dur-
ing the next installation step.
S T
ETTING THE
Each wireless transmitting station must be set to one of eight transmitter IDs.
DIP switches #1, 2 and 3 on the SIM allow you to control the ID — the "chan-
nel" the station will transmit on. (DIP switch #4 is used for transmission test-
ing, not for transmitter ID.)
The transmitter and receiver communicate with each other only when both are set to
the same ID.
The factory default transmitter ID is '1'. Looking at the table on the next page,
you can see that means the DIP switches are in the OFF position when each
transmitting station leaves the factory, whether it is an ISS, a tempera-
ture/humidity station, or another kind of station.
Since the ISS is included with every Wireless Vantage Pro, the console/receiver
is set to find the ISS on '1'. Set your temperature/humidity station to its own
number.
Page 4
3-Volt
Lithium
Battery
S I M
ENSOR NTERFACE ODULE ON
ID
RANSMITTER
Antenna
T /H
EMPERATURE UMIDITY
DIP Switches
S
TATION