Setting Console Station Id On The Console; Setting The Console Station Id Using Weatherlink; Viewing Current Temperature And Humidity - DAVIS Wireless Temperature/Humidity Station Installation Manual

Battery Holder
DIP Switches in Top-right Corner of SIM (Illustration has been enlarged for clarity)

Setting Console Station ID on the Console

1. Put your console into Setup Mode — press and hold DONE and press the
DOWN arrow (-).
The console will show you Screen 1: Transmitters. You should see the words:
"RECEIVING FROM..." and "STATION NO." followed by the transmitter IDs that
your console detects. One of these should be the ID number you just set on the
Temp/Hum Station transmitter. If you don't see it, make sure the console is within
10' of the transmitter, and verify that you set the DIP switches correctly. If you still
don't see it, set your Temp/Hum Station into TEST Mode by following the instruc-
tions on page 7.
2. Press DONE to move on to Screen 2: Selecting Transmitters.
Setup Mode – Screen 2 is where you will set the console to recognize signals on that
ID as coming from a Temp/Hum Station.
3. Press the LEFT (<) or RIGHT (>) arrows to scroll through transmitter IDs.
When you see the ID you chose for the Temp/Hum Station, use the UP or DOWN
arrow keys to activate reception of that ID code. Make sure the screen shows "ON".
4. Press GRAPH to change the type of station assigned to that transmitter ID.
Press GRAPH until "TEMP HUM" appears.
5. To exit Setup Mode, press and hold DONE.

Setting the Console Station ID using WeatherLink

You can also set the console ID for your Temp/Hum Station from WeatherLink ver-
sion 5.2 or later.
• In WeatherLink 5.2 and later set the station type to ISS (TEMP/HUM).

Viewing Current Temperature and Humidity

1. On the console, press TEMP until you see an 'outside' temperature displayed on
the console screen with the correct Station No. displayed above or below it.
2. Press HUM until you see an 'outside' humidity displayed on the console screen
with the correct Station No. displayed above or below it.
ON
1 2 3 4
DIP Switches
5