Table of Contents
Advertisement
Wireless Temp Page 8 Thursday, December 7, 2000 2:09 PM
T
T
ESTING
RANSMISSION FROM
It is very important to test reception from the proposed location before perma-
nently mounting the temperature station.
Place the shelter at the intended mounting site, or have someone hold it there,
so you can walk around with the console/receiver for a few minutes. Rotating
the antenna may help to improve reception.
Test wireless reception anywhere you might want to use or mount your con-
sole/receiver now or in the future. Take your time. If you aren't picking up
strong signals where you intend to place your console, better to move the shel-
ter now than after it has been mounted. Experiment.
If you have irregular terrain in the area, it may interfere with the signal. For
example, if the transmitter is mounted downhill from the console/receiver, the
ground may block a wide angle of the transmitted signal.
M
W
OUNTING THE
IRELESS
Mounting on a Pole
1. While holding the shelter against the pole, place a U-bolt around the pole and
through the two holes on at the top of the shelter.
2. Place a flat washer, a lock washer and a hex nut on each of the bolt ends.
U-Bolt
Page 8
P
ROPOSED
T
S
EMPERATURE
M
T
S
OUNTING
EMPERATURE
TATION ON A
L
OCATION
TATION
Lock
Flat
Washer
Washer
P
OLE
Wireless Temperature Station
Hex
Nut
Advertisement
Table of Contents
