DAVIS Wireless Temperature/Humidity Station Install Manual page 10

2. Slide the stud ends protruding from the top of the station through the holes on the
mounting bracket.
3. Secure the station to the mounting bracket using a #8 flat washer, #8 split lock
washer and #8 hex nut on each of the stud ends.
Tighten the hex nuts until the station is secure on the mounting bracket.
A
TTACHING
M
AINTENANCE
The capacity of the radiation shield to keep fresh air flowing over the sensors will
be reduced if the shield plates become dirty.
Clean the surfaces of the shield plates periodically with a damp cloth.
Keep areas between the shield plates free of debris that may obstruct air flow.
Examples are leaves, twigs, webs, nests.
DO NOT remove nesting insects or animals by spraying insect killer of
any kind into the radiation shield. Chemicals could easily damage the
circuitry inside your temperature/humidity station.
Page 10
#8 Hex Nut
#8 Lock Washer
#8 Flat Washer
Temperature/
Humidity Station
T /H
EMPERATURE
Threaded Stud Ends
S M
UMIDITY TATION TO OUNTING
B
RACKET