DAVIS Wireless Temperature/Humidity Station Install Manual page 5

Use a ballpoint pen or paper clip to toggle DIP switches #1, 2, and 3. The set-
tings for transmitter IDs 1 – 8 are shown in the table below:
ID C
#1
Use this table to ensure that each wireless transmitting station in your system is
broadcasting on its own transmitter ID.
Battery Holder
DIP S
WITCHES IN
Setting Console/Receiver(s) to Same ID
1. Put your console into Setup Mode — press and hold the DONE key and press the
DOWN arrow key.
The console will show you Screen 1: Transmitters. You should see the words:
"RECEIVING FROM..." and "STATION NO." followed by the transmitter
IDs that your console detects. One of these should be the ID number you just
set on the temperature/humidity station transmitter. If you don't see it,
make sure the console is within 10' of the transmitter, and verify that you set
the DIP switches correctly. If you still don't see it, go to "TEST mode".
Setting the Transmitter ID
S 1
ODE WITCH
off
(default)
#2 off
#3 off
#4 off
#5 ON
#6 ON
#7 ON
#8 ON
Antenna
T - C
OP RIGHT ORNER OF
S 2
WITCH
off
off
ON
ON
off
off
ON
ON
ON
1 2 3 4
SIM (I
LLUSTRATION HAS BEEN ENLARGED FOR CLARITY
S 3
WITCH
off
ON
off
ON
off
ON
off
ON
Transmitter ID
Switches
Test Indicator LED
)
Page 5