Table Of Contents - DAVIS Wireless Temperature/Humidity Station Install Manual

T S
OOLS FOR ETUP
In addition to the hardware provided, you will need some or all of the follow-
ing materials:
Adjustable wrench or 11/32" wrench and 7/16" wrench
Ballpoint pen or paper clip (small pointed object of some kind)
Drill and 3/16" (5 mm) drill bit (if mounting on a vertical surface)
Four 1/4" x 1-1/2" (38 mm) lag screws (if mounting on a vertical surface)
I
NSTALLATION
For ease of installation, please follow the steps in the order presented.
Prepare the temperature/humidity station, page 3
Remove shield plates to access the Sensor Interface Module, page 3
Insert the battery, page 4
Set the transmitter ID, page 4
Set ID on the station using DIP switches, page 4
Set the console to recognize the signals, page 5
View current readings, page 6
(If you don't see readings from the correct Station No., put your
temperature/humidity station in TEST mode, page 6)
Choose a location for the temperature/humidity station, page 7
Test transmission from the proposed mounting location, page 7
Mount the temperature/humidity station, page 8
A note on securing cables, page 11
See "Maintenance" on page 10. For Technical Support, see "Contacting Davis
Instruments" on page 11.
Page 2
S
TEPS