Protection Against Contact With Hot Parts - Bosch Rexroth IndraControl VCP 02.2 Project Planning Manual

3-8 Bosch Rexroth AG | Electric Drives and Controls
Safety Instructions for Electric Drives and Controls
3.9

Protection Against Contact with Hot Parts

• Persons with heart pacemakers, hearing aids and metal implants are
not permitted to enter the following areas:
– Areas in which electrical equipment and parts are mounted, being
operated or started up.
– Areas in which parts of motors with permanent magnets are being
stored, operated, repaired or mounted.
• If it is necessary for a person with a heart pacemaker to enter such
an area, then a doctor must be consulted prior to doing so. Heart
pacemakers that are already implanted or will be implanted in the fu-
ture, have a considerable variation in their electrical noise immunity.
Therefore there are no rules with general validity.
• Persons with hearing aids, metal implants or metal pieces must con-
sult a doctor before they enter the areas described above. Other-
wise, health hazards will occur.
CAUTION
Housing surfaces could be extremely hot! Danger of injury! Danger
of burns!
• Do not touch housing surfaces near sources of heat! Danger of
burns!
• After switching the equipment off, wait at least ten (10) minutes to al-
low it to cool down before touching it.
• Do not touch hot parts of the equipment, such as housings with inte-
grated heat sinks and resistors. Danger of burns!
Rexroth IndraControl VCP 02 | R911310375 / 02