Arming Diagnostics; Disarming Diagnostics - Directed Electronics 544T Owner's Manual

d d i i a a g g n n o o s s t t i i c c s s
The microprocessor at the heart of your system is constantly
monitoring all of the switches and sensors connected to it. It is
designed to detect any faulty switches and sensors and prevents
them from disabling the entire system. The microprocessor will
also record and report any triggers that occurred during your
absence. Refer to the System Status Chirps and Table of Zones
sections of this guide for diagnostic information.

arming diagnostics

If the security system is armed at the same time that an input is
active (such as a door opening or sensor triggering), the system
will generate a Bypass Notification. This means that the security
system ignores the input that was active when the system was
armed, until that input ceases. Three seconds after that input
ceases, the security system will resume normal monitoring. For
example, if your vehicle has an interior light exit delay and you
arm your security system before the interior light turns off, you
may hear a Bypass Notification. Once the light turns off,
however, the security system resumes normal monitoring.

disarming diagnostics

Extra chirps that are heard when disarming the system are indi-
cating a Tamper Alert. If four chirps are heard when disarming
the system, a triggered response was generated in your absence.
If five chirps are heard when disarming the system, a zone was
36
© 2002 directed electronics, inc.