Directed Electronics 544T Owner's Manual page 32

To enter or exit Valet mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
switch within 10 seconds.
The status LED will light solidly if you are entering Valet mode,
and it will go out if you are exiting Valet mode.
The transceiver will not generate a page notification when
entering or exiting Valet mode using the Valet switch.
To enter or exit Valet mode using the transceiver:
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solidly if you are entering Valet mode,
and it will go out if you are exiting Valet mode. The transceiver
will generate alarm/disarm page notifications since the observing
buttons are used when entering and exiting valet mode. The
status LED is the only way to ensure the system has
entered/exited valet mode.
28
DRW-35
© 2002 directed electronics, inc.