Valet Take-Over - Directed Electronics 544T Owner's Manual

Transceiver buttons
the vehicle.
The transceiver will generate a page notification with a unique
melody (or vibrate) and the remote start icon (19) will turn off
when the remote start shuts down.

valet take-over

The Valet ® Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
®
To perform Valet Take-Over:
1. Before turning off the engine, simultaneously press and
release and
notification with a unique melody (or vibration) will be
generated and the LCD will display the remote start icon
(19) as long as the vehicle is running. Then wait three
seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote
Start section for a complete list of shut-down inputs.)
note: This feature will not work if the brake pedal is
pressed or if any shut down input is active.
© 2002 directed electronics, inc.
and are pressed again to start
on the transceiver. A remote start page
31