Table of Contents
Advertisement
Fuel Bed Layout.
Fuel bed layout should be fitted using the guidance stipulated on pages 9-15 of the User
Instruction section.
Fit Glass Panel.
Due to transit protection, the glass panel is packed with a protective sleeve within the packed
appliance. Special care should be taken when removing the glass panel from the packing. The
top fixing is attacked to the fire box via 4 off M4 fixing nuts. Remove the nuts and remove the top
fixing bracket. (Please see fig8 within the user instruction section).
Locate the glass panel within the bottom retaining slot and
push back against the seals. (Please see Fig 11).
Position the top fixing bracket over the top edge of the glass
panel and slide over the four M4 studs.
Using the four M4 nuts previously removed. Tighten the top
glass fixing using the nut runner provided with the appliance.
Non reflective glass option.
The non-reflective glass has no print on the glass due to this there is a inner frame provided to be
fitted before the glass panel.
Slide the inner frame into the glass channel and push in to place ensuring the tabs are sitting on
top of the firebox(see below) ensure the frame is central and there is a even gap either side of
the frame (between the side of the firebox and the tabs of the frame)
P a g e
| 37
600 HD INSTALLATION INSTRUCTIONS
Make sure that the gap
here is the same on both
sides of the frame
LT7618 Issue No 1 (06/2018)
Advertisement
Table of Contents
