Jungheinrich ESD 220 Operating Instructions Manual page 54

Checking the battery acid level
Requirements
– Park the truck securely, see page 67.
– Expose the battery, see page 47.
Procedure
• Remove the battery connector (52) from the truck.
• Place the battery connector (52) on the battery (55).
• Pull the battery lock (51) up.
CAUTION!
Unsecured battery
An unsecured battery can result in trapping and injury
uWear safety shoes when removing and installing the battery.
uDo not reach between the battery and the chassis.
• Pull the battery (55) half way out of the truck.
• Release the battery lock (51).
• Keep pulling the battery (55) out of the truck until the lock engages on the battery
again.
• Check the acid level of the battery (55).
All indicators should show sufficient acid level, if necessary add battery water, see
the operating instructions for the traction battery.
• Pull the battery lock (51) up.
CAUTION!
Unsecured battery
An unsecured battery can result in trapping and injury
uWear safety shoes when removing and installing the battery.
uDo not reach between the battery and the chassis.
• Push the battery (55) into the truck.
52
51
52
55