Jungheinrich ESD 220 Operating Instructions Manual page 51

Charging the battery
Requirements
– Expose the battery, see page 47.
– Correct charging program set on
charger.
Procedure
• Remove the battery connector (52)
from the truck plug (53).
• Remove any insulating mats from the
battery.
• Connect the battery connector (52) to
the charging cable
stationary charger.
• Start charging in accordance with the
charger operating instructions.
• Switch on the charger / charging begins automatically.
The battery is now charged.
Completing battery charging, restoring the truck to operation
NOTICE
If charging has been interrupted, the full battery capacity will not be available.
Requirements
– The battery is fully charged.
Procedure
• Complete charging in accordance with the charger operating instructions.
• Disconnect the battery connector (52) from the charging cable (54) of the
stationary charger.
• Attach the battery connector (52) to the industrial truck.
The truck is now ready for operation.
(54) of the
53
52
54
49