Jungheinrich ESD 220 Operating Instructions Manual page 107

Error displays adding a user code
For the following events the LED (92) flashes red:
Cause
– The user code entered is
not the same length as the
master code
– New user code is already
occupied by a master code
– The newly entered user
codes do not match
– Code log full.
Remedy
– Switch off the truck, see page 101.
– Repeat the entry, making sure that the master
code is the same length as the user code.
– Switch off the truck, see page 101.
– Choose a different user code, see page 104.
– Switch off the truck, see page 101.
– Add the user code again, see page 104.
– Switch off the truck, see page 101.
– Delete individual user codes, see page 108.
– Delete all user codes, see page 110.
105