10BASE-T Stackable Hubs
♦ Boot Server IP Address The IP address of the TFTP server where
the configuration file is located. This entry is used only if the S/W
Update Control is enabled and your boot protocol is
you are using
Power Up is enabled, the address will be obtained from the BOOTP
server.
♦ Boot File Name The pathname of the configuration file on your
TFTP server. If you are using SNMP-View as your TFTP server, this
is the pathname of the
used only if your boot protocol is TFTP ONLY; if you are using
BOOTP&TFTP mode, or if Use Bootp to get IP after start up is
enabled, the pathname will be obtained from the BOOTP server.
For more information about SNMP configuration files, consult Appendix C.
For detailed information about using the TFTP and BOOTP servers, consult
the SNMP-View User's Guide.
6-10
bootp-tftp
.CFG
Figure 6 -6 Software Update Menu
mode, or if Send BOOTP Request on
file on your hard disk. This entry is
tftp only
Using the Console Interface
; if