Table of Contents
Advertisement
5100 Insert ACC
B. Securing Stove Pipe/Liner to Flue Collar
1. There are 4 already drilled holes in the flue collar 90
degrees apart. Attach the flue collar to the stove pipe/
liner. f the seal is questionable use high temperature
sealant such as stove mastic (Figure 19.1).
2. Attach gasket to bottom side of flue collar with a thin
coat of silicone.
Flue Collar
Figure 18.1
C. Optional Offset Adapter Installation
In some installations the flue collar and stove pipe/liner do
not always align properly. This situation may be remedied
by using the optional offset adapter. See Appliance
Dimensions page for the amount of distance this accessory
can telescope between the flue collar and stove pipe/liner.
1. Remove the cast iron flue collar from the appliance and
flip it upside down. Using the larger #7 drill bit supplied,
drill through all 8 countersunk locations (Figure 18.2).
2. Slide the gasket over the flue collar and attach it to the
offset adapter using the 8-32 flathead screws provided
(Figure 18.3).
3. Adjust the offset adapter to desired distance. Drill holes
through the lower chamber as shown in Figure 18.2
using the small drill bit #26 provided.
4. Cut the gasket to the proper length and slide in
between the upper and lower chambers centered on
the screw holes. Attach the upper and lower chambers
with screws provided (Figure 18.3).
5. Repeat the process on the bottom side.
Cast Iron Flue Located on Appliance
Drill through all 8 countersunk
locations
Figure 18.1
18
Gasket
Stove Pipe/Liner
Figure 18.2
Once distance is established, drill holes
and secure both chambers together.
Figure 18.3
Figure 18.4
7047-910J
January 13, 2020
Advertisement
Table of Contents
