Table of Contents
Advertisement
D. Leveling Legs
1. Remove the 2 screws already installed on each leg.
2. Move legs to the desired height.
3. Re-install the screws to secure in place.
Remove 2 screws from both sides.
Adjust the legs up or down to level
appliance.
Figure 19.1
E. Securing Appliance to Stove Pipe/Liner
1. Once you have the appliance in place and secured,
reach up through the flue opening and grab the
attachment bar and pull down inside flue opening
(Figure 19.2).
2. Insert the 5/16 bolts inside the cast flue and through
the chimney mounting bar. Securely tighten the nuts.
Fasteners are provided.
3. Re-install the tube channel assembly, baffle board,
ceramic blanket and baffle protection channel.
Attachment Bar
Attachment
Bar
Figure 19.2
January 13, 2020
Chimney Mounting Bar
5/16 Bolts
5/16 Nuts
F. Surround & Trim Kit Installation
1. Lay surround face down on a protected surface to
prevent scratching.
2. Using a Phillips head screw driver attach the side
surrounds to the top surround using 2 #8 sheet metal
screws provided with the kit (Figure 19.3).
3. Lay the trim face down and place the corner brackets
into position.
4. Using a standard flat screw driver tighten the corner
brackets (Figure 19.4).
5. Slide the trim over the surround set.
6. Install the surround set and trim set to the outer can.
Place the hook in the surround sides over the surround
attachment screws, 2 on each side (Figure 19.5).
7. Place top on top of appliance.
Secure 2 Side Surrounds to
Figure 19.3
Corner Brackets
Figure 19.4
STOVE TOP
Figure 19.5
7047-910J
5100 Insert ACC
Top Surround
SURROUND
ATTACH POINTS
19
Advertisement
Table of Contents
