Show Users; Disconnect; Port-Based Network Access Control Commands; Authentication Login - D-Link DES-3226L Cli Command Reference

86 D-Link DES-3226L Command Line Reference

show users

This command displays the configured user names and their settings. This command is only available
for users with Read/Write privileges.
system.
Format
Mode
User Name
Access Mode
SNMPv3 Access Mode
SNMPv3 Authentication
SNMPv3 Encryption

disconnect

This command closes a telnet session.
Format
Mode

Port-Based Network Access Control Commands

This section describes the commands you use to configure Port-Based Network Access Control (IEEE
802.1X). Use Port-Based Network Access Control to prevent unauthenticated devices from accessing
the network through the directly-connected port.

authentication login

This command creates an authentication login list. The <listname
case sensitive. Up to 10 authentication login lists can be configured on the switch. When a list is
created, the authentication method "local" is set as the first method.
When the optional parameters "Option1", "Option2" and/or "Option3" are used, an ordered list of
methods are set in the authentication login list. If the authentication login list does not exist, a new
authentication login list is first created and then the authentication methods are set in the authentication
login list. The maximum number of authentication login methods is three. The possible method values
are
local, radius
The SNMPv3 fields will only be displayed if SNMP is available on the
show users
Privileged EXEC
The name the user enters to login using the serial port, Telnet or Web.
Shows whether the user is able to change parameters on the switch (Read/
Write) or is only able to view them (Read Only). As a factory default, the
"admin" user has Read/Write access and the "guest" has Read Only access.
There can only be one Read/Write user and up to five Read Only users.
This field displays the SNMPv3 Access Mode. If the value is set to
the SNMPv3 user is able to set and retrieve parameters on the
ReadWrite,
system. If the value is set to
retrieve parameter information. The SNMPv3 access mode may be different
than the CLI and Web access mode.
This field displays the authentication protocol to be used for the
specified login user.
This field displays the encryption protocol to be used for the speci-
fied login user.
disconnect {<sessionID> | all}
Privileged EXEC
and .
reject
the SNMPv3 user is only able to
ReadOnly,
is any character string and is not
>