Hypertext Transfer Protocol (Http) Commands; Ip Http Secure-Port; No Ip Http Secure-Port; Ip Http Secure-Protocol - D-Link DES-3226L Cli Command Reference

Layer 2 switch, 24 port 10/100 managed switch plus 2 combo gigabit copper/sfp ports
Hide thumbs Also See for DES-3226L:
Table of Contents

Advertisement

102
D-Link DES-3226L Command Line Reference

Hypertext Transfer Protocol (HTTP) Commands

This section describes the commands you use to configure Web-based access to the device.

ip http secure-port

This command is used to set the sslt port where port can be 1-65535 and the default is port 443.
Default
Format
Mode

no ip http secure-port

This command is used to reset the sslt port to the default value.
Format
Mode

ip http secure-protocol

This command is used to set protocol levels (versions). The protocol level can be set to TLS1, SSL3 or
to both TLS1 and SSL3.
Default
Format
Mode

ip http secure-server

This command is used to enable the secure socket layer for secure HTTP.
Default
Format
Mode

no ip http secure-server

This command is used to disable the secure socket layer for secure HTTP.
Format
Mode

ip http server

This command enables access to the switch through the Web interface. When access is enabled, the user
can login to the switch from the Web interface. When access is disabled, the user cannot login to the
Web server on the switch.
Disabling the Web interface takes effect on all interfaces immediately.
443
ip http secure-port <portid>
Privileged EXEC
no ip http secure-port
Privileged EXEC
SSL3 and TLS1
ip http secure-protocol [SSL3] [TLS1]
Privileged EXEC
disabled
ip http secure-server
Privileged EXEC
no ip http secure-server
Privileged EXEC

Advertisement

Table of Contents
loading

Table of Contents