speed
This command sets the speed and duplex setting for the interface.
Format
Mode
Acceptable values are:
100h
100f
10h
10f
speed all
This command sets the speed and duplex setting for all interfaces.
Format
Mode
Acceptable values are:
100h
100f
10h
10f
storm-control broadcast
This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port
exceeds the high threshold percentage (as represented in Table 7) of the link speed, the switch discards
the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or less. The full
implementation is depicted in Table 7.
Table 7. Broadcast Storm Recovery Thresholds
10M
100M
1000M
Format
Mode
speed {100 | 10} {half-duplex | full-duplex}
Interface Config
100BASE-T half duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
speed all {<100 | 10> <half-duplex | full-duplex>}
Global Config
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
Link Speed
20
5
5
storm-control broadcast
Global Config
Setup and Management Commands
High
10
2
2
39
Low