Show Snmptrap - D-Link DES-3226L Cli Command Reference
Layer 2 switch, 24 port 10/100 managed switch plus 2 combo gigabit copper/sfp ports
Hide thumbs
Also See for DES-3226L:
- Manual (134 pages) ,
- Reference manual (228 pages) ,
- User manual (110 pages)
Table of Contents
Advertisement
Link Up/Down Flag
Multiple Users Flag
Spanning Tree Flag
show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP
Network Manager. These messages alert the manager to events occurring within the switch or on the
network. Six trap receivers are simultaneously supported.
Format
Mode
SNMP Trap Name
IP Address
Status
Can be enabled or disabled. The factory default is enabled. Indicates
whether link status traps will be sent.
Can be enabled or disabled. The factory default is enabled. Indicates
whether a trap will be sent when the same user ID is logged into the switch
more than once at the same time (either via telnet or serial port).
Can be enabled or disabled. The factory default is enabled. Indicates
whether spanning tree traps will be sent.
show snmptrap
Privileged EXEC
The community string of the SNMP trap packet sent to the trap man-
ager. The string is case sensitive and can be up to 16 alphanumeric characters.
The IP address to receive SNMP traps from this device.
Indicates the receiver's status (enabled or disabled).
Setup and Management Commands
49
Advertisement
Table of Contents
