Set Igmp Groupmembership-Interval; No Set Igmp Groupmembership-Interval; Set Igmp Maxresponse; No Set Igmp Maxresponse - D-Link DES-3226L Cli Command Reference

set igmp groupmembership-interval

This command sets the IGMP Group Membership Interval time on one interface or all interfaces. The
Group Membership Interval time is the amount of time in seconds that a switch waits for a report from a
particular group on a particular interface before deleting the interface from the entry. This value must be
greater than the IGMPv3 Maximum Response time value. The range is 2 to 3600 seconds.
Default
Format
Modes

no set igmp groupmembership-interval

This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
Modes

set igmp maxresponse

This command sets the IGMP Maximum Response time for the system, on a particular interface or
VLAN. The Maximum Response time is the amount of time in seconds that a switch will wait after
sending a query on an interface because it did not receive a report for a particular group in that interface.
This value must be less than the IGMP Query Interval time value. The range is 1 to 3599 seconds.
Default
Format
Modes

no set igmp maxresponse

This command sets the IGMP Maximum Response time (on the interface or VLAN) to the default
value.
Format
Modes

set igmp mcrtexpiretime

This command sets the Multicast Router Present Expiration time. The time is set for the system, on a
particular interface or VLAN.
This is the amount of time in seconds that a switch waits for a query to be received on an interface
before the interface is removed from the list of interfaces with multicast routers attached. The range is 0
to 3600 seconds. A value of 0 indicates an infinite time-out, i.e. no expiration.
260 seconds
set igmp groupmembership-interval <vlanId> <2-3600>
Interface Config
Global Config
no set igmp groupmembership-interval
Interface Config
Global Config
10 seconds
set igmp maxresponse <1-3599>
Global Config
Interface Config
VLAN Mode
no set igmp maxresponse
Global Config
Interface Config
VLAN Mode
Switching Commands 63