Reload; Copy - D-Link DES-3226L Cli Command Reference

physical path between the switch and the workstation. The terminal interface sends three pings to the
target station.
Format
Modes

reload

This command resets the switch without powering it off. Reset means that all network connections are
terminated and the boot code executes. The switch uses the stored configuration to initialize the switch.
You are prompted to confirm that the reset should proceed. The LEDs on the switch indicate a
successful reset.
Format
Mode

copy

This command uploads and downloads files to and from the switch. You can specify local URLs using
tftp or xmodem. You can specify one of the following four files as the source file for uploading from the
switch: startup configuration (
(
nvram:traplog
<ip address>/<filepath>/<filename>) for the destination.
Use the
copy
specifying the source URL and destination as
nvram:script,
validates the script. In case of any error, the command lists all the lines at the end of the validation
process and prompts you to confirm before copying the script file.
Use the
copy
nvram:sshkey-rsa2
for more information.
Use the
copy
,
root nvram:sslpem-server
information, see "Hypertext Transfer Protocol (HTTP) Commands" on page 102.
Use the
copy
system:running-config
Default
Format
ping <ipaddr>
Privileged EXEC
User EXEC
reload
Privileged EXEC
nvram:startup-config
) and configuration script (
command to download the startup configuration, code image or configuration script by
respectively. During the download of a configuration script, the
command to download secure shell (ssh) key files, including
, and
nvram:sshkey-dsa
command to download HTTP secure-server certificates, including
,
nvram:sslpem-dhweak
command to save the running configuration to nvram by specifying the source as
and the destination as
none
copy nvram:startup-config <tftp://<ipaddr>/<filepath>/<filename>>
copy nvram:errorlog <tftp://<ipaddr>/<filepath>/<filename>>
copy nvram:script <scriptname> <tftp://<ipaddr>/<filepath>/<filename>>
copy nvram:traplog <tftp://<ipaddr>/<filepath>/<filename>>
copy system:running-config nvram:startup-config
copy <tftp://<ipaddr>/<filepath>/<filename>> nvram:clibanner
copy <tftp://<ipaddr>/<filepath>/<filename>> nvram:script
copy <tftp://<ipaddr>/<filepath>/<filename>> nvram:sshkey-dsa
copy <tftp://<ipaddr>/<filepath>/<filename>>nvram:sshkey-rsa1
copy <tftp://<ipaddr>/<filepath>/<filename>> nvram:sshkey-rsa2
System Maintenance Commands
), error log (
nvram:errorlog
nvram:script <scriptname>
nvram:startup-config
. See "Secure Shell (SSH) Commands" on page 100
, and
nvram:sslpem-dhstrong
nvram:startup-config
), trap log
). Specify a URL (tftp://
, or
system:image
command
copy
nvram:sshkey-rsa,
nvram:sslpem-
. For more
.
119