Mercedes-Benz E-Class Sedan Operator's Manual page 371

1 Front roof area
2 Rear roof area
3
Rear fender
4 Trunk lid
On vehicles with a panoramic sliding sunroof,
installing an antenna on the front or rear roof
area is not permitted.
On the rear fenders, it is recommended that you
position the antenna on the side of the vehicle
closest to the center of the road.
Use Technical Specification ISO/TS 21609 (Road
Vehicles – EMC guidelines for installation of
aftermarket radio frequency transmitting equip‐
ment) when retrofitting RF (radio frequency)
transmitters. Comply with the legal requirements
for detachable parts.
If your vehicle has installations for two-way radio
equipment, use the power supply or antenna
connections intended for use with the basic wir‐
ing. Be sure to observe the manufacturer's sup‐
plements when installing.
Two-way radio transmission output
The maximum transmission output (PEAK) at the
base of the antenna must not exceed the values
in the following table:
Technical data 369
Frequency band and maximum transmission
output
Frequency band Maximum transmis‐
Short wave
3 - 54 MHz
4 m band
74 - 88 MHz
2 m band
144 - 174 MHz
Trunked radio sys‐
tem/Tetra
380 - 460 MHz
70 cm band
420 - 450 MHz
Mobile communica‐
tions (2G/3G/4G)
sion output
100 W
30 W
50 W
10 W
35 W
10 W